Lightweight 0.8mm gold plated bullet connectors, ideal for micro models. Each connector pair weighs 0.35g. Good for 5A continuous current. Supplied as a pack of 5 pairs including heatshrink tube.

Lightweight 2mm gold plated bullet connectors, ideal for lightweight models. Good for 20A continuous current. Supplied as a pack of 5 pairs including heatshrink tube.

2mm gold plated bullet connectors, ideal for lightweight models. Good for 20A continuous current. Supplied as a pack of 5 pairs including heatshrink tube.

3.5mm gold plated bullet connectors. Good for 60A continuous current. Supplied as a pack of 5 pairs including heatshrink tube.

4mm gold plated bullet connectors. Good for 80A continuous current. Supplied as a pack of 5 pairs including heatshrink tube.

3.5mm gold plated bullet connectors with plastic shroud - as used on E-flite electric models. Convenience of a small connector with easy assembly, polarised and self-insulated. The bullet connectors are soldered to wires and then press-fit into the shroud. Good for 60A continuous current. Supplied as a pack of 3 pairs.

The conventions are that the male bullet plugs are inserted into the female shroud; the female bullet sockets into the male shroud; and the male shroud/female bullet connectors are used on the battery lead.

These micro 2 pole, polarised connectors, sometimes referred to as 'Micro Deans', are usefull in battery to ESC connection when normal Deans style connectors would be too heavy. These are good for up to 10A. Supplied as a pack of 3 pairs including heatshrink tube.

These Deans style 2 pole, polarised connectors are good for heavy current battery to ESC connection. The connector internal resistance is much lower than for a bullet connector: e.g. 90 micro ohm for the Deans and 200 micro ohm for 4mm bullet. These connectors are good for up to 100A continuous current and are supplied as a pack of 3 pairs including heatshrink tube.

Mounts one Deans female plug flush on the outside surface of your fuselage or power panel. Laser cut from quality materials. Includes all fasteners and doubler plate for your balsa fuselage. Use as a charging or test port. Also very useful as a key activated switch.

Want a switch on your large electric model that can take the punishment? Use this mount and a shorting plug and you're there and without all the problems and resistance inherent in normal switches.

Note: this mounting box is designed to fit genuine Deans Ultra plugs. Some 'Deans style' connectors have different dimensions and may not fit the mounting box. The standard size Deans style connectors sold by Micron have moulded ridges on the side to aid in pulling the connectors apart - these will require filing down to fit the box.

The box mounts from outside of fuselage or panel. Use the included doubler as a template to cut your mounting hole.

5 packs of plug or socket shells and crimps - used for power leads. The plug is the connector normally fitted to the battery lead. This connector is good for up to 5A.

A pack of 5 red and 5 black miniature crocodile clips useful for temporary electrical connections. Wires are attached to the clip by soldering. The clip is mostly covered by a plastic shroud or "boot" to prevent accidental short-circuits. Its toothed jaws open to 7mm with a positive grip and they are suitable for all low voltage wiring configurations.

Robust 4mm sprung contact plugs to use on the end of charge leads - the curved springs is probably why they are called 'banana plugs'. They have a 4mm hole in the side so that they can be stacked and screw type clamp for your wire. Available in black and red.